Steps to Configure Initial Router Settings
Pre-requisite: Cisco Router basic commands.
Routing is the method of selecting a network packet path over the Internet or between or through multiple networks. Routing is conducted on many kinds of networks, including circuit-switched networks, such as public switched telephone networks (PSTN), and computer networks, such as the Internet.
In this article, we will see configure the router in Cisco Packet Tracer.
Steps to Configure the Router:
Step 1. Open the packet tracer desktop and take a Router (2911) and PC0 from the devices.
- Connect the router0 with PC0 with the help of a console cable.
- Then, click on PC0 and go to the terminal, and type y.
- Finally, we can configure the router with the help of a PC.
Step 2: Configure the Host name of the router0.
- Click on PC0 and go to the terminal.
- Then change the hostname to “r1”
router> router>en router#conf t router(config)#hostname r1 r1(config)exit
Step 3: Set a message of the day (MOTD) banner for the users.
r1(config)#banner motd $
then, enter MOTD and end it with ‘$’ to exit.
r1(config)#banner motd $ Enter TEXT message. End with the character '$'. Unauthorised access is strictly prohibited $
Step 4: setting up line control password and enable secret password
To configure the Line Control password and Enable secret follow the below commands:
r1#conf t r1(config)# r1(config)#line con 0 r1(config-line)#password GFG123 r1(config-line)#login r1(config-line)#exit
r1(config-line)#enable password cisco r1(config)#enable secret GFG@123 r1(config)#service password-encryption sh(config)#exit
Step 5: Verifying password
- When you try to log in first, it will ask for the line control password.
- Then, to configure the terminal it will ask to enable a secret password.
To save the configuration use the below command:
r1#copy run startup-config
Contact Us