Redirecting Standard Error

The redirection operator > only redirects the standard output (stdout) of a command. To redirect the standard error (stderr), you need to use the file descriptor 2.

2> stderr

The 2> operator redirects the standard error (stderr) of a command to a file. This separates error messages from the regular output, providing a cleaner output. The syntax is as follows:

command 2> file

Consider an example:

eccho "gfg" 2>file.txt
echo "gfg" 2>file.txt

There is no command as echo and hence error message will be displayed. But if 2>file.txt is used, then the error will be redirected to file.txt and no error is displayed on the screen. The cat command can be used to display the content of the file named file.txt which is the error message for the previous command. While executing the second command, gfg is displayed as the echo is a command in Linux to display. Hence, 2> does not redirect standard output.

2>&1

The 2>&1 operator redirects both standard error (stderr) and standard output (stdout) to the same file or stream.

Syntax:

command > file 2>&

Consider an example:

eccho "gfg" >error.txt 2>&1
echo "gfg" >error.txt 2>&1

There is no command as echo and hence the error message is redirected to the file error.txt and no error is displayed. The second command echo “gfg” is correct but still, no output is displayed, as the standard output is also redirected to the file error.txt. The content of the file can be displayed after each step using the cat command.

Note: >& can be used to redirect both standard output and standard error, but it is not supported in all shells. sh and ksh do not support >& while bash and zsh support it.

Redirection is a feature in Linux which can be used to change the standard input device (keyboard) or standard output device (screen) during the execution of a command. The basic process of any Linux command is that it takes an input and gives output but the standard/input and output can be changed using the redirection technique.